COURSE OBJECTIVES FOR EQUIPMENT PROBLEMS: PROTOCOLS, IDENTIFICATION & REPAIR TECHNIQUE
The purposed of this module are:
- Introduction to common block diagram and circuit diagram for electrical and electronic equipment.
- Equipped the trainee on Identify and verify technique based on equipment problems and symptoms.
- Equipped the trainee on Protocols, Safety Tips, Testing Method, Troubleshooting and Repairing Technique of Electronic Equipment.
LEARNING OUTCOMES
The end of this training, the trainee will be able to:
- Simplify and identify equipment problems.
- Simplify the equipment block and circuit diagram.
- Generate Test Method and Safety Tips for equipment testing.
- Verify problems area / status of board assembly
- Repair and replace faulty board.
- Apply equipment repair technique to any type of equipments.
WHO SHOULD ATTEND
- University /College
- Equipment Repair Centre
- Maintenance Department
- Production Department
- Equipment Supplier
- Technician & Engineer
COURSE CONTENT
DAY 1
- Introduction to Equipment Problems , Identification , Testing , Verification and Repair Technique
- Introduction to Electrical / Electronic Equipment Block Diagram
- Circuit / Assembly Function
- Equipment Basic Block Diagram
- Equipment Basic components / Parts.
- Practical 1- Generates Electrical/ Electronic Equipment block Diagram
- Circuit analysis 1 : Common Problems & Symptom in Switch mode Power Supply (SMPS) – Input Section
- Basic circuit function.
- Test Point and Measurement Technique
- Common fault and symptom
- Circuit analysis 2 : Common Problems & Symptom in Main Controller – Control Section
- Basic circuit function.
- Test Point and Measurement Technique
- Common fault and symptom
- Circuit analysis 3 : Common Problems & Symptom in DC Motor with Controller Unit
- Basic circuit function.
- Test Point and Measurement Technique
- Common fault and symptom
- Circuit analysis 4 : Common Problems & Symptom in Heater Assy with Control unit
- Basic circuit function.
- Test Point and Measurement Technique
- Common fault and symptom
DAY 2
- Safety precaution & protocols on PCB/Equipment Testing
- Practical 2 : Testing and Verify status of Switch Mode Power Supply
- Generate Test Point , Testing and verify status of Power Supply
- Practical 3 : Testing and Verify status of Basic Micro Controller
- Generate Test Point and , Testing and verify status of Basic Micro Controller
- Practical 4 : Testing and Verify status of Output Devices
- Testing and verify status of assembly device
- AC Motor
- Heater Assembly
- DC Motor
- Testing and verify status of assembly device
- Practical 5 : Testing, Verify and Repair technique of DC Motor Controller Board
- DC Motor Controller Testing Technique
- PCB Repair on DC Motor Controller
- PCB Assembly Layout
- Part Pin Configuration
- Short Open Test
- Voltage Bias Test
- Reference
